1996-03-05- to 1996-05-15 ATM-min

Browse Search

�j • 24S, Article 29 7 Section 9. Residential Developments a. the lot area in a conventional subdivision shall be at least the minimum required by Table 2,Schedule of Dimensional Controls,for the zoning district in which the lot is located.(See also paragraph 9.4.3. which requires a greater lot area for larger houses.)The lot area in a cluster subdivision, a special residential development or a development with significant public benefit may be such size as the SPGA may approve; b. the dwelling may be newly constructed and does not need to have been constructed by January 1,1983; c. the maximum floor area of the accessory apartment shall be: 1) not more than 1,200 square feet,or 2)not more than 30 percent of the living area of the dwelling, whichever is less. d. paragraph 5.2.2.b.2,which prohibits enlargement of existing dwellings,shall not apply. 9.3.8 EQUIVALENT DENSITY The maximum density of a facility permitted by 9.2.2 h, i, k,`1, or m. in which living units or other accommodations are not dwelling units,(See Definition.)shall be determined by paragraph 9.2.9 Equivalent Density. • 9.4 CONVENTIONAL SUBDIVISION 9.4.1 MEANING OF"CONVENTIONAL SUBDIVISION" A conventional subdivision is a residential development with three or more dwelling units in which a tract of land is divided into lots for constructing single family detached dwellings. (See also the Definition, Conventional Subdivision.) 9.4.2 DIMENSIONAL STANDARDS A conventional subdivision shall comply with the applicable dimensional standards set forth in subsection 9.2 and elsewhere in Section 9 for the residential development as a whole.Each lot created within a conventional subdivision must comply with the dimensional standards set forth in Table 2 and elsewhere in this By-Law. 9.4.3 ACCESSORY APARTMENT If an accessory apartment is included in a dwelling,as provided in paragraph 9.3.7,and if the dwelling has a gross floor area that is 6,200 square feet or more,the minimum lot area shall be 20,000 square feet in the RS district and 35,000 square feet in the RO district.If the dwelling in which the accessory apartment is included has a gross floor area that is less than 6,200 square feet, the minimum lot area shall be 15,500 square feet in the RS district and 30,000 square feet in the RO district. 9.4.4 ADDITIONAL STANDARDS APPLICABLE TO CONVENTIONAL SUBDIVISIONS In addition to the dimensional standards set forth in subsection 9.2 that apply to a residential development as a whole,the following shall also apply to an individual lot in a conventional subdivision approved after May 4, 1987: RS, RT DISTRICT RO DISTRICT a. Maximum Impervious Surface Ratio 0.20 0.12 and if a dwelling,including any addition thereto,which has a gross floor area of 2500 square feet or more,is erected thereon, it shall have: b. Minimum Side Yard 25 feet 25 feet Minimum Rear Yard 25 feet 25 feet